Tapioca starch production in Thailand - production process analysis

With the development of the Thai tapioca starch production processing, small cassava processing lines have been gradually ignored, but the small processing line of tapioca starch production in Thailand has the following characteristics: Firstly, the input is low, the production efficiency is high, and the return rate is high; the second is the small footprint of the device, the process is environmentally friendly; the other is the fully automated production line can effectively reducing the production cost.

Tapioca starch production plant

Putting the cassava into the washing machine to eliminate the soil and pollutants from the surface, then pour the raw material into the hopper to improve the process. Pour the cassava into the upper hopper, and spray it through the spray pipe during the lifting process, which is highly efficient and energy-saving, and can be customized depending on customer requirements. Tapioca starch production in Thailand is good because of the high clearing rate.

The most important thing after cleaning is the crushing process. In the traditional tapioca starch production in Thailand, the knife-type crusher and the hammer mill is invoked as a set, but even if the two machines are used together, the best pulverization effect is not achieved. This brings a series of problems, and the final result is that the extraction rate of tapioca starch will be greatly reduced, so the production efficiency will be decreased.

Tapioca starch production machine

The disadvantage of the hammer mill in tapioca starch production in Thailand is that the particle size of the crushed material is not uniform. The structure of this tapioca starch machine is composed of the feeding mechanism, the crushing chamber (rotor, hammer, sieve, tooth plate), the discharge part (fan, collecting cylinder. However, it is now the most widely used type of pulverizer. The amount of power is high and the versatility is good. Some hammers and rotors are connected. After the metal foreign matter enters the pulverizer, it only breaks the sieve and does not occur a major accident. So the previous tapioca starch production in Thailand was not very effective.

Cassava milling machine

During the processing of tapioca starch production in Thailand, the feed enters the crushing chamber from the feeding mechanism, and flies toward the tooth plate under the impact of the high-speed rotating hammer. After the collision with the tooth plate, it is hit again by the hammer, and between the sieve surface and the hammer, the feed It is also strongly rubbed, and under repeated impact collision and friction, the feed is gradually pulverized, and the pulverizer without a fan causes the pulverized material to be discharged through the sieve hole by the airflow in the pulverization chamber for tapioca starch production in thailand. After the pulverizer with a fan extracts the pulverized material from the sieve hole, it is necessary to separate the air in the mixed gas stream from the pulverization by a starch collecting device (such as a collecting cylinder, a dust collecting bag, etc.).

Tapioca starch drying machine

The design scheme of tapioca starch production in Thailand adopts advanced, scientific, reasonable and mature technical processes at home and abroad: one-time cleaning, secondary pulverization, secondary washing, separation, dehydration, and negative pressure airflow drying process, which has high yield and high whiteness. Advantages of fewer impurities. Tapioca starch production in Thailand equipment model: 3-5 tons per hour to 35 tons per hour capacity.

DOING tapioca starch manufacturing plant of tapioca starch production in Thailand is mature because the quality of the equipment is guaranteed and it is early enough to enter the Thai market.